Pinealon — Complete Dosing Protocol & Guide

Pinealon is a sleep peptide — the sleep category covers deep rest, circadian rhythm, recovery sleep. Pineal gland peptide bioregulator (Glu-Asp-Arg tripeptide, Khavinson school) that supports melatonin production, circadian rhythm entrainment, and healthy sleep architecture. In research settings it is administered subcutaneous or oral at a frequency of once daily, with an elimination half-life of ~minutes to hours and a studied dose range of 1 mg–2 mg per administration (about 15 mcg/kg of body weight).

Pineal gland peptide bioregulator (Glu-Asp-Arg tripeptide, Khavinson school) that supports melatonin production, circadian rhythm entrainment, and healthy sleep architecture. That mechanism places it in the sleep category. Pharmacokinetically, its elimination half-life of ~minutes to hours is what shapes the once daily dosing cadence used in research protocols, and the full effect builds across a 10-20 days cycle followed by 3-6 months off — which is why the dosing is cycled rather than continuous.

Pinealon is taken subcutaneous or oral — subcutaneous injection into abdominal fat is the standard research route. The research-standard frequency is once daily, with a half-life of ~minutes to hours. Research protocols time it 30–60 minutes before bed to support deep-sleep architecture. Always start at the low end of the dose range, use aseptic technique for injections, and follow the 10-20 days cycle followed by 3-6 months off. PeptideWise calculates the exact dose and schedule for your body weight and goal.

Research protocols use 1 mg–2 mg per administration, weight-based at roughly 15 mcg/kg of body weight, administered once daily. For an 80 kg (176 lb) adult that works out to about 840 mcg for a beginner, 1 mg for an intermediate, and 1.2 mg for an advanced research protocol. Start at the bottom of the range and titrate up only while the response is tolerable — the personalized protocol engine on this site computes the exact figure for your weight.

The standard research cycle is 10-20 days, followed by 3-6 months off. Cycling matters because continuous exposure leads to receptor desensitization (tachyphylaxis) — the same dose produces less effect over time — and side effects fade during off periods. Don't extend the cycle past 10-20 days chasing diminishing returns.

Yes. Pinealon is commonly researched alongside Epithalon (Epitalon), DSIP (Delta Sleep-Inducing Peptide). The best stacks pair peptides that act through different mechanisms toward the same goal — for example BPC-157 (angiogenesis) with TB-500 (cell migration). Introduce one peptide at a time, align cycle lengths, and cap stacks at 2–3 peptides so effects stay attributable. The protocol engine on this site only recommends stack combinations that pass safety screening for your conditions and medications.

Reported in research and trial settings: mild injection site reaction; vivid dreams. Most are dose-dependent and resolve when the dose is reduced or the cycle ends. If any severe reaction occurs (chest pain, severe abdominal pain, difficulty breathing, signs of an allergic response), stop immediately and seek medical evaluation.

Pinealon carries a good research safety profile at the doses described above, but safety is individual. It is contraindicated in research settings with: pregnant, breastfeeding. It is not medical advice to run any peptide without supervision — consult a qualified healthcare provider who knows your full history first, get baseline labs, and re-check during the cycle. 😴 As a sleep peptide, Pinealon is sold for research use only.

Pinealon is sold by research-chemical suppliers for laboratory research use only — it is not an approved dietary supplement or consumer product, and regulations vary by country and jurisdiction. Before considering any source: (1) consult a licensed healthcare provider about medically supervised options, (2) if purchasing for research, verify third-party certificates of analysis (COA) confirming purity and identity, and (3) be wary of prices that look too good to be true — they usually are. PeptideWise does not sell peptides; we provide dosing research and protocol tools.

Pinealon ships lyophilized (freeze-dried) and must be reconstituted before use. Use bacteriostatic water: inject it slowly down the inside wall of the vial (never directly onto the powder), then swirl gently — never shake, as shaking denatures the peptide. Example: a 5 mg vial + 2 mL of bacteriostatic water gives 2.5 mg/mL, so a 250 mcg dose is 10 units (0.1 mL) on an insulin syringe. Store the reconstituted vial refrigerated at 2–8°C and use within 2–4 weeks. See the full step-by-step reconstitution guide for concentration math and storage.